Loading the content... Loading depends on your connection speed!

Adding a bead, ‘Sticky Style’!


I am finishing up the last few rows of this panel, for the cell phone bag. (I got a bit ‘side tracked’ with another beading projects and some book writing!) There have been times, through out my looming, where I missed a count or left a bead color off a row, having to pull all the beads off and recount or find the place I dropped. There are many ways of correcting this mishap, but I found one way to be the easiest.

Enlarge the row of beads, in the picture below. Notice how many different colors are added to the needle, row for row. At any given time, a bead color can be over looked or a count of any bead can be missed. Instead of pulling the entire row off the needle, I like to use my ‘sticky method’ of replacing that ‘missed bead’.

Using a white ‘paper tape’, I tape down a strip, sticky side up. This is something I keep by my side, while I loom, often. The paper tape does not leave any ‘glue residue’ and is ‘just as adherent as any other tape.

After noticing there is a bead missing, while punching the beads upwards, between the warps, I recount to find the bead I must be missing. My first thought is how I hope it is one of the last beads put on the needle. Of course, it can’t always be that easy! When I find the ‘needed bead’, I’ll stick the row of ‘keeper beads’ on to the sticky side-up, of the paper tape. Then I pull out the thread and needle, exiting the entire row. The tape will keep the row in order, so I can re-thread the same beads, without having to follow the pattern again!

After I add the ‘needed bead’, then I run the needle back into the row, stuck on the tape. I can then continue to loom!

I wrote an earlier post, on how I remove an ‘extra’ bead, from my needle and thread. Again, I use a pair of pliers or small wire cutters, to catch ‘just the edge of the bead I want to remove’ and ‘crack it’ away-from-the-thread. Cracking any glass bead, directly over the thread it is threaded, will cut the thread.

Leave a Comment

Current ye@r *