Loading the content... Loading depends on your connection speed!

Confetti Crystal and Bead Necklace Weave-Along: Week One

It’s time to whip out your nude loom and that new pretty crystal and bead kit your just bought and find out how easy and fun it is to make a beautiful necklace to keep or to share.  If you wear, everyone you know will want one.  I hadn’t even escaped from my house with my just finished necklace when it was immediately claimed by a friend.

As I believe I mentioned elsewhere, it took me three attempts to get this necklace just right.  I am glad I spent the time because I think this is a timeless and workable design that will be both fun to weave, but fun to change up a bit.  You might want to organize your beads slightly differently from the way I do it.  Keep in mind that you are going to have to weave the same number of rows of crystals (the kit comes with 100 crystals which is more than you need to weave and finish the necklace if you weave one row of crystals for every four rows of beads) that I’ve woven but you can organize them differently . . . ie., more randomly . . . if you like.

If you look closely you can see the pattern I created.  The piece (although you can’t see it here) starts with a row of two crystals.  What follows is a solid row of four beads.  Then one of those beads, two of a different color of beads and another one of those beads and then the pattern repeated backwards so that you get a square within a square.  Next weave another row of crystals and continue with a different color combination of beads.  You want to spread your five bead and five crystal colors throughout that piece.  But first we need to set up the loom.  Don’t worry, this won’t take more than a few minutes.


Extend your loom so that are 18 inches between the top and bottom beam.  This is the highest you can extend the 8 and 12 inch looms.  If you have a 16 inch loom, you can extend it a little more which will give you slightly more length to your fringe.

You will not need a warp coil (spring) on your loom.  Center the piece as much as possible.  There will be three groups of warp threads with three threads in each group.  Essentially, you will be putting nine warps on the loom. If you’ve never warped before, follow along on our online .pdf warping instructions. Just remember that you don’t need to use a warp coil!

That’s it! Next week we’ll begin weaving!

 

2 Responses to Confetti Crystal and Bead Necklace Weave-Along: Week One

  1. Vanita Sorensen - Reply

    November 25, 2012 at 9:51 pm

    Do we need to use warping bar or can one just warp continuously around the top and bottom bar?

    • Elena Zuyok - Reply

      November 26, 2012 at 10:32 am

      We always suggest using a warping bar as this gives you a place to tie your warp and allows you to advance your weaving.

Leave a Comment

Current ye@r *

Follow Us!