Loading the content... Loading depends on your connection speed!

Rag Mug Rug Weave-Along

Stuff you’ll need:

A Mirrix Loom with a shedding device and an eight dent spring.  I am using the LaniLoom.

 

IMG_3473

 

Carpet warp.  Maysville cotton carpet warp is fine.  I am using cotton rags however.  If you are using woolen rags, I would suggest wool warp:  http://www.mirrixlooms.com/store/navajo-wool-warp/

 

 

 

 

 

IMG_3474

This is a picture of my warp on a rag runner I wove 25 years ago (please don’t do the math!)

IMG_3471

 

Rags.  These lovely balls of rags were stripped when I wove the rag runner.  I used first quality fabric.  Make a cut in the fabric about one inch wide (or however wide you want your strips to be) and then rip the fabric. It makes a lot of dust so you might want to do this outside.

IMG_3470

A basket of balls of rag strips.

IMG_3472

 

A good beater.  One of our weighted ones will work well:  http://www.mirrixlooms.com/store/weighted-tapestry-beater/  The below beater is brass.  Again, something I have had since the last century and which is no longer made.

A tapestry needle for tying off the warp ends.

IMG_3514

Warping your loom

My rag mug rug is going to be a tad less than 4 inches wide.  In order to accomplish this I have used an 8 dent spring and have put on 34 warps.  Please see warping instructions for Warping for tapestry using the shedding device: http://www.mirrixlooms.com/beginners-guide/warping-instructions/

IMG_3475

 

IMG_3476

IMG_3478

 

Rotate your piece to the back of the loom

You will want to weave a second piece because why not?  Your loom is already warped and you have enough warp to do so.  And besides, you can’t make just one mug rug!

IMG_3504

Cutting the piece off

I have cheated.  I only made one mug rug (got a deadline here!).  You can either cut the piece off cutting as close to the warping bar as possible, or simply release the tension on  your loom and let the warping bar slip out while your piece comes crashing down.
IMG_3506

Finishing the Piece

I have incorporated the header end into my first overhand knot so there are three ends in the side knot.  Make an over-hand knot.  Stick your tapestry needle in the knot to push it close to the weaving.  Knot a pair of warps on the other side of the piece and then knot all the interior pairs of warps. If you end up with three warps at some point, just knot them together.

IMG_3507

 

IMG_3508

IMG_3509

 

Trim the ends to a length you like.  Remember, these ends will show.

IMG_3510

 

Your finished piece!

Now make yourself a cup of tea and see if this little mug rug does the trick.

 

 

IMG_3512

3 Responses to Rag Mug Rug Weave-Along

  1. Judy Flanders - Reply

    December 15, 2013 at 3:21 pm

    what a fun idea. Only complaint is that the print is pale grey and some of it I cannot read.

    • mirrixlooms - Reply

      December 16, 2013 at 2:28 pm

      This is something we are looking into changing for the whole site.

  2. parham - Reply

    July 6, 2014 at 3:30 am

    Rag Mug Rug Weave-Along

Leave a Comment

Current ye@r *