Social Market for a Craftartedu.com Course: Chris Franchetti Michaels, Tapestry Weaving, Uncategorized
This week in the CraftArtEdu Introduction to Tapestry Class I took on a combination pick and pick plus hatching technique, along with geometric chevrons.
Pick and Pick Plus Hatching and Warp Interlock
This is the first time in the class that we combine techniques to create an interesting effect. We’ve already covered basic pick and pick, but now we’re adding the color blending technique called hatching as well as a new way to create the boundary between colors by using warp interlock.
I started out with pick and pick, using blue and black yarn. Because I started these wefts initially going in the same direction, I wove the blue yarn one extra time. This put the wefts in opposite directions, which is required for the next technique, warp interlock.
Warp interlock is similar to weft interlock, which we used earlier in the class, except that you wrap the yarn around a shared warp, rather than around each other.
Here’s my first warp interlock, at the center of the tapestry between the blue and black weft yarns.
We’re using this interlock to begin the next technique, which is called hatching. With hatching, you blend one color into the other using a series of partial horizontal lines. Hatching can be simple, like we’re doing in this tapestry, or it can be very complex and used to create subtle artistic effects.
Here’s my piece after several rows of even hatching with the blue and black.
Next, we move into some pick and pick, eventually adding in some purple yarn. Notice that the black vertical lines are on different warps than they were the previous time we did pick and pick.
After several more rows of purple, it was time to advance the weaving, which means to move it down on the loom to free up space on the warps at the top. To do this, you need to loosen the tension and then pull the warping bar on the back of the Mirrix loom upward.
In this next photo, I’ve advanced my weaving so that much of the already-completed tapestry is now facing the bottom and back of the loom.
After advancing the weaving, it’s a good idea to check your top warp spring. I find that mine often pulls down out of its bracket while advancing and needs to be pushed back up.
At this point in the class it was time to make chevron shapes. I had never made these before. Although their principle is simple, I struggled a little with keeping my wefts in the proper sheds.
You start by marking the boundaries of the bottoms of the chevrons with short lengths of yarn, just like we did for slit tapestry. A note here: although the class calls for seven warps between markers (if I’m interpreting it correctly), I actually found that I needed eight warps between markers in order to have the correct number of color blocks.
Next, you need to lay in your different colors of weft yarns in opposite directions. This is also like we did previously with slit tapestry. Just like back then, I had to watch my pattern of hills and valleys, but I can tell I’m gradually getting better at this.
I should point out that we are technically using slit tapestry here, but instead of making blocks with straight borders, the borders will create chevron, or zig-zag, shapes. To start making them, you need to shift over by one warp with each of your colors. For me, this is where the technique got a little complicated. I’m sure I made a minor mistake here and there, but overall I was able to keep the chevron shapes looking relatively even as I went along.
Here are the first two shifts toward the right.
And here are all of the rightward shifts completed.
You may notice that not all of my wefts are running opposite to one another anymore, darn it…. Still, I was able to fix things enough to proceed. The next step was to start shifting back in the opposite direction for the top halves of the chevrons. And here they are.
Pretty cool, eh? I figure it’s not bad for my first attempt. After the last row, I went back and made sure all of the yarns were in the same shed so that I’ll be properly set up for the next technique. Stay tuned for my next post to find out where it takes us.
Chris Franchetti Michaels is a bestselling craft book author and designer. Visit her blog at http://www.beadjewelry.net.