Sometimes you want to make a piece that’s much thinner than the width of the loom you’re weaving on. If you weave a thin piece in the center of your loom, you may have the problem of an unstable warping bar when you remove the bar from the clips after you warp. To prevent this, we recommend weaving either two thin pieces on either side of your loom, or weaving one thin piece on one side of your loom and then balancing the warping bar on the other side of the loom with a string or ribbon.
Here is an example of a piece woven on one side of the loom where the warping bar is being balanced by a piece of ribbon:
There is, however, an easier way if you are not using the shedding device (because you need the clips to hold the shedding device) and you do not need to advance your piece. (Note: You advance your piece when you are weaving a piece that is longer than the front of your loom. To do this, you bring your warping bar down to the bottom of the loom before weaving. Once you have woven up as far you can on the front of the loom, you loosen your tension and slowly begin to bring the warping bar up the back of the loom. This moves your piece from the front to the back of the loom, leaving you more room to weave on the front).
The warping bar is unbalanced here
This method is something that many of you already do. Simply keep your warping bar in the clips when you begin weaving. It balances the warping bar perfectly and you can warp your piece on one side or in the middle of your loom! Depending on how extended your loom is, you can even advance your weaving some using this method by simply moving the warping bar and the clips up the loom.
Easy! What other Mirrix tricks do you use? Let us know in the comments!