Loading the content... Loading depends on your connection speed!

Set-Up and Warping Instructions

Download our free ebook “Weaving is Easy!” that goes over loom set-up, warping and weaving with links to videos, e-books and more!

Don’t know how to warp a Mirrix Loom? It’s easy! Just click the type of weaving you’ll be doing and you you’ll be brought to a step-by-step instructional document in .pdf form. Can’t open the .pdf? Download the Adobe .pdf reader here free.

 

Warping the 5″ Mini Mirrix Loreli Loom (.PDF) warpingpdfmini

 

 

 

 

warpingpdftapestry Warping for Tapestry with the Shedding Device (.PDF)

 

 

 

 

warpingpdfwarpingwosd Warping for Bead Weaving without the Shedding Device (.PDF)

 

 

 

 

warpingpdfbeadworkwsd Warping for Bead Weaving with the Shedding Device (.PDF)

 

 

 

 

warpingpdfnowarpendskit

Warping with the No Warp-Ends Kit (.PDF) (Note: These instructions show warping with paperclips, not s-hooks. The concept is the same as with the s-hooks)

Warping with the No Warp-Ends Kit (.PDF) (Note: These are more basic instructions, shown with s-hooks)

 

 

How to switch plastic clips for wooden ones: If your loom came with plastic clips and you want to switch to the newer wooden clips. This is how to install the new clips: Requires a flat nose plier to remove bushing from inside copper side bars so you can slip the clip on the loom will it will remain permanently.

Separate the top and the bottom parts of the loom (just slide the top part off) and then remove the bushings from inside the copper side bar (the silver-colored piece that is inserted into the copper) with a pair of flat nose pliers. Then you can slip the wooden clip onto the bar. Replace the bushing and place the top part of the loom back onto the bottom part.