Warping is Easy!
The question we get the most at Mirrix is some variation of: Is warping difficult?
The simple answer is: Warping is easy!
Warping a basic piece on a Mirrix is very simple. It just takes a little practice to become an expert. Doing a very wide piece and adding the shedding device and heddles is a little more complicated, but once you get the basics down you’ll be ready to take on any warping challenge! Following are 15 pictures that go over the basic warping procedure. For more detailed warping instructions take a look at one of our warping .pdfs here.
1.) Your Mirrix Loom comes already set up. Simply fold out the leg/s, set the loom to your desired height and make sure both sides are even.
2.) Take your wooden clips and flip them backwards, so the white screws are facing the front of the loom.
3.) Place your warping bar in the indentations between the clips on the back of your loom. Press the clips together slightly to hold the bar securely.
4.) Place a warp coil (also called a spring) in the top tray. This will help set the spacing for your piece. Some thin pieces don’t need a coil.
6.) Bring your warp thread down the back of the loom and under the bottom beam (note: you could also go in the opposite direction, but we’ll just show you one direction here).
8.) Bring your thread over the top of the top beam and down the back of the loom until you reach the warping bar.
11.) When you reach the bottom beam, bring your warp thread under the bottom beam from the front to the back.
14.) Bring your warp thread under the bottom of the loom front back to front and start heading up the front of the loom.
15.) Head back up the front of the loom and place your warp thread in the next space (or “dent”) over.
That’s it! Keep warping in this pattern. It really is as easy as wrapping your warp thread around your loom and changing direction when you hit the warping bar.